Water Methanol, 2.5 Gal (9.3L) Reservoir w/ fittings & brackets (13Lx9.5Hx7.5w)
Water Methanol, 7 Gallon Reservoir (w/ bracket, solenoid & hose) (15Lx17Hx9W)
Water Methanol, Carb Plate
Water Methanol, Dual Nozzle Upgrade
The gasoline Stage 1 System kit is very versitile. It can be used in naturally aspirated or forced induction applications. The system includes an adjustable boost activated switch for forced induction applications as well as a Wide Open Throttle switch for naturally aspirated applications.
This system uses a progressive controller that proportionally injects more or less according to manifold vacuum. Start and full points are adjustable for engagement and delivery curve, to match what the engine requires.
Run 11:1 to 13:1 compression ratio (or more) on pump gas!! Increase your pump gas octane by 20-25 points and make more power. More power and efficiency with cooler running for your naturally aspirated V8 Muscle Car.
This system uses the 0 to 5 Volt output signal from the Mass Air Flow sensor on many fuel injected vehicles. This means that any vehicle with a MAF (with a 0-5V output signal) can use this system, whether they are naturally aspirated or forced induction. If the application is forced induction, it can be used with very fast-spooling turbos, or positive displacement blowers.
This system uses manifold boost pressure to determine when and how much fluid to inject. Proportionally injecting according to boost pressure gives the most accurate delivery of water-methanol and allows the most cooling and performance improvement over the widest range. More power and driveability is the result.
This kit uses the unique GM MAF frequency Hz output signal or a 0-5 volt signal. Perfect for naturally aspirated applications and forced induction applications that build boost quickly at lower rpms.
The NX GAS Stage 3 is unmatched for accuracy and adjustability in water-methanol injection systems. This system can be used on any forced induction engine, or ANY engine with a traditonal EFI system, and features our LCD display with on-the-fly adjustability. Extremely easy to set up and dial in - the software creates a delivery map based on boost or EFI signal from just a few easy to set points you punch in from the drivers seat.
The Stage 3 MPG MAX is unmatched for increases in Fuel Economy AND Power in water-methanol injection systems. Key to this is accuracy and adjustability designed into the system.
Level Switch Upgrade w/red LED
The Low Flow Safety Switch for use with NX water/methanol injection systems can trigger a boost cut solenoid or a timing retard module. It is designed to activate a safety mode in case you run out of Water/Methanol. The Low Flow Safety Switch allows for a safe tune in those instances where no Water/Methanol injection is present and an aggressive tune when Water/Methanol is utilized.
Nozzle Mounting adapter for hose 1/8in NPT
Nozzle Mounting Bung for Aluminum 1/8" NPT
Nozzle Mounting Bung for Steel 1/8" NPT
Solenoid Upgrade(fluid flow)w/fittings