Fra:
Haltech
Elite 2500 Terminated Engine Harness For Ford Falcon BA/BF Barra 4.0L I6
9.998,75 DKK
m/Moms
(
7.999,00 DKK
u/Moms
)
INJECTOR CONNECTOR: Factory Bosch EV1
SUITS: Ford Barra Engine found in BA/BF Variants Barra 182,190, 240T, 245T, 270T
INCLUDES: - Includes Engine Harness & Fuse Block - Connector Pack - Quick Start Guide
NOTES: - Suits Factory Bosch EV1 injector connectors - Ignition module is NOT included. Please order HT-020036 if required)
Model/varenr.:
HT-141388
Lager:
Leveringstid er 1-2 uger, hvis udsolgt. dag(e)
Ikke på lager
Harness Overview
The fastest and most cost-effective way to wire your race car or engine conversion! Simply connect a handful of labelled wires and this plug and Play product allows you to be up and running in just a few hours.
- An efficient Haltech Plug'n'Play product that allows you to be up and running in just a few hours.
- The quick start guide will walk you through installation of the Haltech Plug'n'Play harness into your vehicle.
- The guide is accompanied by the full ECU manual and Software located on the CD or USB key provided with the ECU to refer to while completing your installation and configuration.
Harness Features
- This harness when installed in conjunction with a Haltech Elite ECU opens the door to virtually limitless performance modification and tuning of your vehicle.
- Fully programmable systems allow you to extract all the performance from your engine by delivering precisely the required amount of fuel and ignition timing that your engine requires for maximum output under all operating conditions.
Der er endnu ikke nogen anmeldelser her. Vi vil være glade for hvis du vil anmelde som den første.
